Make your own Balancing Bottle Holder

What You’ll Need

Piece of Wood 2 ¾” x 8 ¼”

Table Saw

Miter Saw

Router with Round-over Bit

1 ¼ drill bit

Drill or Drill press

Sandpaper (orbital sander)

How to make it...

Step One

Cut a piece of wood to 2 ¾ inches wide.

Step Two

Round over the edges of the blank, including at least one end.

Step three

Mark the center, or 1 3/8 inches in, near the top of the blank

Step Four

Make a mark 1 ¾ inches down from the top.

Step Five

Measure 7 ½ inches down from the top of the blank and make  a mark.

Step Six

Cut the blank at the 7 ½ inch mark at a 40 degree bevel.

Step Seven

Using an 1 ¼ forstner or spade bit, drill a hole at the top of the blank where your lines intersect.

Step Eight

Round over the edges of the hole.

Step Nine

Sand the bottle holder and finish as desired.